Added function for BlueMod configuration: Investigations of connection problems showed that there is a problem if the module is not able to forward data fast enough. The bottleneck in direction of microcontroller may be solved by increasing baud rate. To be backward (bootloader) compatible this is done temperoraly during every startup Added function for signal stregth evaluation: Quality of data connection may have an impact on stability => added function to visualize current state of connection. The evaluation may be requested remote using 'l' (0x6c) or by pressing next button while in service mode Cleanup Disconnection procedure: Disconnection issued by OSTC was realized by simply switching of the module which might have a negativ impact to remote devices. Second reason for change was that, e.g. in case of a timeout on OSTC side. a remote device might have continued sending firmware data causing OSTC to interpretate firmware image as service requests. E.g. resulting in a corrupted configuration. Instead of just switching off power a disconnection request is now send to the BlueMod. Decreased size used for large data receiption: Depending on device speed firmware transfer might be really slow. By decreasing the block size a short (6 seconds) timeout per block may be kept while the sender has more time for transfering the image

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef COMPASS_H
#define COMPASS_H

#include <stdint.h>

void compass_init(uint8_t fast, uint8_t gain);
void accelerator_init(void);
void compass_read(void);
void acceleration_read(void);
int compass_calib(void);
void compass_calc(void);
//void compass_calc_mini_during_calibration(void);
 
float check_compass_calib(void);

void compass_sleep(void);
void accelerator_sleep(void);

#endif /* COMPASS_H */