Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 686:b1e24513b83e Betatest
Bugfix Battery charge complete event:
In previous version it could happen that the battery charge state was set to 100% even the battery was not completly charged. Rootcause was that the external charger IC signals sometimes completion because e.g. the connection between charger unit and OSTC is disconnected within a short time slot. This may happen while the user is trying to get the OSTC in a good charging position. To avoid this the state machine now checks the voltage everytime for valid charging complete range before a charging complete is signaled.
| author | Ideenmodellierer |
|---|---|
| date | Fri, 05 Aug 2022 14:56:17 +0200 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |