Mercurial > public > ostc4
view Documentations/dump-rte.cfg @ 861:ad96f99ebc78 Evo_2_23 tip
Synchronize ADC and UART activities:
depending on the cable configuration the UART sensor operation may have an impact to the ADC measurement (peaks). To avoid this the ADC measurements are now only started in case no UART communication is pending.
author | Ideenmodellierer |
---|---|
date | Tue, 07 May 2024 21:25:25 +0200 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f411RETx set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run #puts "Flash banks:" #flash banks #puts "Reading..." #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 #puts "Done." #exit