Added function for BlueMod configuration: Investigations of connection problems showed that there is a problem if the module is not able to forward data fast enough. The bottleneck in direction of microcontroller may be solved by increasing baud rate. To be backward (bootloader) compatible this is done temperoraly during every startup Added function for signal stregth evaluation: Quality of data connection may have an impact on stability => added function to visualize current state of connection. The evaluation may be requested remote using 'l' (0x6c) or by pressing next button while in service mode Cleanup Disconnection procedure: Disconnection issued by OSTC was realized by simply switching of the module which might have a negativ impact to remote devices. Second reason for change was that, e.g. in case of a timeout on OSTC side. a remote device might have continued sending firmware data causing OSTC to interpretate firmware image as service requests. E.g. resulting in a corrupted configuration. Instead of just switching off power a disconnection request is now send to the BlueMod. Decreased size used for large data receiption: Depending on device speed firmware transfer might be really slow. By decreasing the block size a short (6 seconds) timeout per block may be kept while the sender has more time for transfering the image

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef PRESSURE_H
#define PRESSURE_H

#include <stdint.h>

uint8_t init_pressure(void);
void pressure_set_offset (float pressureOffset, float temperatureOffset);

uint8_t pressure_update(void);
void pressure_update_alternating(void);

uint8_t is_init_pressure_done(void);

HAL_StatusTypeDef  pressure_sensor_get_pressure_raw(void);
HAL_StatusTypeDef  pressure_sensor_get_temperature_raw(void);
void pressure_calculation(void);

float get_temperature(void);
float get_pressure_mbar(void);
float get_surface_mbar(void);

uint8_t is_surface_pressure_stable(void);
float set_last_surface_pressure_stable(void);

void init_surface_ring(uint8_t force);
void update_surface_pressure(uint8_t call_rhythm_seconds);

uint32_t demo_modify_temperature_and_pressure(int32_t divetime_in_seconds, uint8_t subseconds, float ceiling_mbar);

#endif /* PRESSURE_H */