Adds a simple countdown timer, available as a custom view in surface and dive mode. This can be used to time safety stops, or to prebreathe a CCR (or to boil your breakfast eggs if you are so inclined). The duration of the timer is configurable from 1 second to 9:59 minutes in the System menu. The timer is started by switching to the custom view, and remaining on it until a 10 second delay has elapsed. Once the timer has started the custom view can be changed and the timer will continue running in the background. After the timer has run out 'Finished' will be shown for 10 seconds in the timer custom view, and then automatic switching of custom views (if configured) resumes. In surface mode the dive computer will not go to sleep while the timer is running, and a mini timer will be shown when the timer custom view is not showing. (mikeller)

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit