Debounce fallback warning: In previous versions the fallback option (automatical setting of a fixed setpoint) was only done for communication timeout scenario in combination with a HUD. It is now also applied in case all sensors are rated as out of bounds. The signaling of the fallback warning (including optional automatic setpoint change) is now done taking a 5 seconds debounds time into account. In case a fallback warning is active, then the only way to reset it is by selecting a new setpoint or by changing the sensor configuration (no change compared to previous implementation

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit