VPM table mode: Because of the model maths, usage of float data type and so on it may happen that the TTS decreases during ascent and continues calculation of the vpm. To keep the values stable the vpm table mode has been introduces. Instead of continously calculation of the stops the stop time is decreased if the diver is close to a deco stop. If the table is violated (e.g. by not doing gas change) the table will be updated to the new, longer runtime. The table will not be switch back to a shorter version in case e.g. the missed gas change is performed

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit