Mercurial > public > ostc4

view Documentations/dump-rte.cfg @ 642:c737cf5d9067

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Do not show focus indicator in case motion detection is suspended: Motion detection will be suspended in case the diver is operating the OSTC using the buttons. In previous versions the focus indicator was shown even the motion detection was not active => may cause confusion. The indicator is now only shown in case the detection is active Added hystresis for switching between sector views: In previous versions small jitter at the angle signal could cause fast switching of the custom view. An offset has now been added to avoid this scenario
author Ideenmodellierer
date Wed, 24 Mar 2021 21:28:41 +0100
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit