Added compile variant enabling the reset of profile sample information: In case the sample ring has an overrun prior to the header ring then header will point to no longer available sample locations causing problems when the no longer existing samples are read. To avoid this also in earlier versions a variant has been added which enables the user to reset the invalid sample information by selecting the problematic dive in the infolog menu and pressing the middle button. Added function which confirms consistency of dive log settings: Meaning last dive and dive header are valid at startup. Repair and find lastDiveID are only called in case a inconsistency is detected

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit