view Documentations/dump-rte.cfg @ 856:af035b883382 Evo_2_23

Do not show SP tab if PSCR mode is active: In the previous version the setpoint tab was shown even if operation mode PSCR was selected. SPs do not matter for PSCR operation and will not be shown in the new version.
author Ideenmodellierer
date Sun, 05 May 2024 17:20:56 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit