Dev Bugfx Empty buffer indication and stability improvments: The mux prototype used ASCII coding for channel selection while the current realization used real number (0...4) for addressing the mux. The UART read function uses the '0' to indicate an empty buffer element. The mux now loops back '0' used by channel selection causing the read function to process the data. As result data interrups are visible at the display. To avoid this another character has been defined indicate empty buffer locations. Beside this the functionality has been improved with regard to access speed and better recovery in case of transition failure.

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit