Bugfix: fix initial CNS data in the logbook header Apparently, there has been confusion in the past about the data format of the CNS data in the logbook. This seems to be partially fixed back in 2015, but this fix forgot that the initial CNS data is also in the logbook header. So, now, the logbook header also stores the initial CNS data in a correct way, which fixes the problem of strange CNS values at the very start of repetitive dives, that get reset in the dive profile after the first CNS sample data comes along. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit