cleanup, RTE: factor out scheduleCheck_pressure_reached_dive_mode_level The detection of the start of dive mode is conceptually simple (when the pressure sensor reaches a certain threshold, we are diving). This said, there are multiple implementations over the entire code base to answer the question: are we diving? This commit factors out scheduleCheck_pressure_reached_dive_mode_level used only in the RTE, in favor of is_ambient_pressure_close_to_surface, which is used in both RTE and CPU1 firmware. I had a little hope that is would fix the 1 second difference between the initial stopwatch and the divetime, but it does not. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit