Mercurial > public > ostc4

view Documentations/dump-rte.cfg @ 684:9bc817e9e221 Betatest

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Ignore automatic setpoint changes during ascend: In the previous version setpoint changes which have been configured for descending were considered for deco calculation in case one or more additional diluents have been activated. This procedure does not fit to the common way to keep setpoint high till end of the dive in order to get rid of the deco time. In the new implementation the OSTC assumes that the current setpoint is used till the end of the dive.
author Ideenmodellierer
date Thu, 02 Jun 2022 20:24:59 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit