Mercurial > public > ostc4
view Documentations/dump-rte.cfg @ 684:9bc817e9e221 Betatest
Ignore automatic setpoint changes during ascend:
In the previous version setpoint changes which have been configured for descending were considered for deco calculation in case one or more additional diluents have been activated.
This procedure does not fit to the common way to keep setpoint high till end of the dive in order to get rid of the deco time.
In the new implementation the OSTC assumes that the current setpoint is used till the end of the dive.
author | Ideenmodellierer |
---|---|
date | Thu, 02 Jun 2022 20:24:59 +0200 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f411RETx set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run #puts "Flash banks:" #flash banks #puts "Reading..." #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 #puts "Done." #exit