view Documentations/dump-disc.cfg @ 276:8e9c502c0b06 IPC_Sync_Improvment_3

Rework pressure/ temperature data aquisition The data data provided by the I2C data had been used for calculation independend if transmission was successfull or not => state evaluation added In the previous version data with resolution 0.5mBar and temperature was requested per cycle inparallel. This has been replaced by a requested resolution of 1mBar and an alternating aquisition (pressure / temp update every 200ms instead every 100ms) => reducing busy wait time and power consumption
author ideenmodellierer
date Sun, 28 Apr 2019 10:06:27 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit