Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 276:8e9c502c0b06 IPC_Sync_Improvment_3
Rework pressure/ temperature data aquisition
The data data provided by the I2C data had been used for calculation independend if transmission was successfull or not => state evaluation added
In the previous version data with resolution 0.5mBar and temperature was requested per cycle inparallel. This has been replaced by a requested resolution of 1mBar and an alternating aquisition (pressure / temp update every 200ms instead every 100ms) => reducing busy wait time and power consumption
author | ideenmodellierer |
---|---|
date | Sun, 28 Apr 2019 10:06:27 +0200 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f427IIT6 | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 puts "Flash banks:" | |
21 flash banks | |
22 | |
23 #puts "Reading FIRMWARE..." | |
24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
26 | |
27 #puts "Done." | |
28 exit |