Enable sensor check for Analog PPO2 mode: Checks which may trigger a fallback warning were not activated in previous versions. Beside enabling the checks the test logic has been changed. Before the change an avarage was build automatically using the remaining both sensors if one sensor failed. The scenario that also one of the remaining sensors may be out of bounds was not covered. The new implementation allows an out of bounds detection for all sensors in parallel. In that special case the last valid value will be used until the diver takes action (Fallback warning)

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit