Mercurial > public > ostc4
view Documentations/dump-rte.cfg @ 555:573a2bc796c8
Added HW_Info to Discovery <=> RTE data exchange:
The information if an external ADC is supported and the type of the compass is forwarded to the Firmware software. This is especially needed to enable the menu structure to support calibration of external sensors
author | Ideenmodellierer |
---|---|
date | Thu, 12 Nov 2020 19:48:28 +0100 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f411RETx set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run #puts "Flash banks:" #flash banks #puts "Reading..." #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 #puts "Done." #exit