Bugfix ppo2 high/low check in OC mode: The fallback option which is used in CC mode was applied to the OC mode as well. As result the check could be deactivated depending on the fallback state, even if a OC dive is performed. now the check will always be performed if the dive mode is OC. Added vibration warning: The internal buzzer of the GPIO_V2 may now be used as additional warning notificator. It can be activated using the check button in the customer view menu. The vibration will be active while the warning message is displayed in the dive window. In case the diver is in the menu then the warning will be active for a shorter duration.

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit