view Documentations/dump-rte.cfg @ 408:2fc08a0d1ec3 Improment_NVM

Bugfix invalid voltage / temperatur after coldstart: In case of a cold start (complete power on / off) the RTE could send devie data before values like voltage or temperature have been measured for the first time. As result the device history data was set to it limits causing a minimal voltage of 2V to be displayed in history memory. Workaround for voltage is to initialize it to 6V at startup but for temperature a default value having no impact to the history memory is not possible
author ideenmodellierer
date Sun, 12 Jan 2020 19:50:14 +0100
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit