Mercurial > public > ostc4

view Documentations/dump-rte.cfg @ 291:24ff72e627f4 div-fixes-6

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Deco Models: limit NDL to 240 minutes Limit the deco models to report up to 240 minutes of NDL. This was triggered by commit 54d14bc2083c. The logbook uses a 8bit UINT, so storing a value of 300 is impossible (which was taken care of in that commit). But, as the small OSTCs also use 240 min. as maximum NDL, we better do that here too (from a consistency point of view). And while we are at it ... kick out some commented and useless code. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>
author Jan Mulder <jlmulder@xs4all.nl>
date Thu, 02 May 2019 09:16:07 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit