Mercurial > public > ostc4
view Documentations/dump-rte.cfg @ 420:2174fb133dbe ImprovmentNVM_2
Optimize ef_write_block function:
The function did single byte writing until a start of a page was detected. Only in that case a multi byte write was used. According to the manual page write is not limited to 256 byte. Multiple bytes may be written until the end of the page is reached
=> Changed implementation to always use multi byte writes which increases the performance of the write block function
author | ideenmodellierer |
---|---|
date | Mon, 10 Feb 2020 19:15:27 +0100 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f411RETx set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run #puts "Flash banks:" #flash banks #puts "Reading..." #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 #puts "Done." #exit