cleanup: also write gas and setpoint changes in simulator mode This is related to the previous commit. There is all kinds of logic around that distinguishes real diving mode and simulator mode. This is valid in certain cases. For example, we do not want a simulator session to act as a repetitive dive for subsequent real dives. What is simply wrong, is skipping relevant logic, like gas switches to act differently in the simulator and in a real dive. The main advantage of this commit is code simplicity. Normal users will never see the difference, as simulator dives are not logged (unless compiled in by a developer). Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit