Bugfixes and code cleanup for BF views: BF views gauge and apnoe were using "dive computer" T3 view functions which caused some problem because these legacy views were not intended to work with customer view selection. A switch condition has been added to skip these kind of functions in case a design other T3 is in use. Another potential problem was that there were two definitions for T3 and T7 views which were basically the same. If they wold not be the same the switching functionality wold not work properly. To avoid this problem in futur the arrays have been merged => the view are handled sing the (newer) cv_view arrays instead of the standard_views which were in used before the user could the views which should be shown.

--- a/Discovery/Inc/tHome.h	Wed Dec 27 19:24:44 2023 +0100
+++ b/Discovery/Inc/tHome.h	Wed Dec 27 19:37:17 2023 +0100
@@ -80,7 +80,7 @@
 		CVIEW_Charger,
 		CVIEW_CcrSummary,
         CVIEW_Timer,
-		CVIEW_END = 31			/* The ID is used in shift operation => 31 is the max number of supported views */
+		CVIEW_END			/* The ID is used in shift operation => 31 is the max number of supported views */
 };
 
 enum CUSTOMVIEWS_BF