Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 853:de6023cc0580 Evo_2_23
Potential Bugfix Selection MenuEdit lifecycle:
The "id" as well as the "evid" were used in two workflows. The setup of the menu structure and later in the handling of e.g. actual cursor position. In case of sructure updates while the menu was opened this lead to misbehavior in the menu handling. To avoid this in future the two usecased of the variables have been separated. The creation of the menus is still handles by "id" and "evid". The handling of the actual menu behavior is controlled by "actualId" and"actualevid"
| author | Ideenmodellierer |
|---|---|
| date | Thu, 07 Mar 2024 21:51:18 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |