Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 1063:a3f42192da0f Icon_Integration
Always use polling mode for CO2 operation:
In the previous version the CO2 sensor was operated in streaming mode (2 measurements a second) in case it was used stand alone (without multiplexer). This added some complexity to the implementation (setup, error handling etc). To reduce this the sensor will now always be operated in polling mode like it is done for multiplexer operation. To make sure that the correct mode is set a command has been added to the configuration steps.
| author | Ideenmodellierer |
|---|---|
| date | Wed, 11 Feb 2026 18:35:44 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |
