Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 483:90d1f793dcf2 FixLayout_Header_LogView
Development option only read bottledata:
If the header divisor is set (in my case because of switching between development and main versions) the samples need to be read considering the bottle values, too. Divelogs written by a SW not supporting bottle pressure have the divisor set to 0 => no impact to main SW
Bugfix header memory layout:
The batterygaugeregisters were not used and will be reused for other information. To keep the OSTC3 format up and running the datafield is not filled with "0x00"
| author | ideenmodellierer |
|---|---|
| date | Tue, 26 May 2020 21:12:02 +0200 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |