Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 973:79b522fbabe6 Evo_2_23
Deactivate deco gas calculation option:
In the previous version had the option to consider a deco gas i the calculation or not. Reason for this was to have the automatic gas suggestion available while the deco calculation is still based on the current gas.
This might cause a critical situation in case the diver is not sure if the option is active or not => In the new version the TTS / deco is always calculated considering all deco gases.
| author | Ideenmodellierer |
|---|---|
| date | Sun, 26 Jan 2025 19:31:38 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |