Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 740:5078da3845c0
Added button lock after wakeup in surface mode:
During setup of diveequipment the OSTC4 is sometimes operated unintended (e.g. while equipping the jaket). To avoid this it is now possible to activate a button lock in the button lock sensitivity menu. The OSTC4 will then wakeup as usuall but if the diver wants to oerate the menus he has to press the buttons in a certain order. The button to be pressed is indicated by a blue bar. The button lock is deactivated in dive mode.
author | Ideenmodellierer |
---|---|
date | Thu, 02 Feb 2023 17:35:38 +0100 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f411RETx | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 #puts "Flash banks:" | |
21 #flash banks | |
22 | |
23 #puts "Reading..." | |
24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
25 | |
26 #puts "Done." | |
27 #exit |