Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 406:439874690f85 Improment_NVM
Bugfix Min max values for device data checks:
Devicedata was set to it lower limit in case of a lower invalid value and upper limit in case a bigger value was detected. This could cause the history memory to be set to a min / max limit and never beeing updated again => Implemented a selection to specify which limit shall be used as default.
Minor change: "header" was used as global as well as as local variable => changed name for global variant to gheader.
Operation hours were not updated =>adde check for opeartion hours
| author | ideenmodellierer |
|---|---|
| date | Sun, 12 Jan 2020 17:57:11 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |