Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 305:305f251cc981 cleanup-4
bugfix, consistency: show deco/NDL really after 1 minute divetime
Related to commit 02d10d955be2. We intended to show deco/NDL after
1 minute divetime, but we included the surface seconds as well.
And yes, this can hardly be called a bugfix. Its simply more
consistent to relate the actual divetime on the display (which
is without surface seconds) with the appearance of deco/NDL after
exactly 1 minute, instead of about 1 minute.
Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>
author | Jan Mulder <jlmulder@xs4all.nl> |
---|---|
date | Tue, 21 May 2019 11:11:05 +0200 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f411RETx | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 #puts "Flash banks:" | |
21 #flash banks | |
22 | |
23 #puts "Reading..." | |
24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
25 | |
26 #puts "Done." | |
27 #exit |