Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 193:255326edf00b div-fixes-cleanup-1
Bugfix: show proper dive mode
The dive mode shown in the top line on the display was strange. It
could only show CCR and OC, and dive modes Apnea and Gauge where
shown as OC. With this commit, the proper dive mode is shown. Notice
that these strings/abbreviations where not localized, and are still
not localized with this commit. The localized names from the
corresponding menu lines are not really usable (as too long) to shown
in the header.
Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>
| author | Jan Mulder <jlmulder@xs4all.nl> |
|---|---|
| date | Sat, 16 Mar 2019 21:52:06 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |