Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 888:07af9efd7c13 Evo_2_23
Dev bugfix: Consider decogas in planner independen from calculation setting:
Some time ago the selection if a deco gas is used for live deco calculation or not was introduced. The planner did not consider the option as well causing it to ingnore deco gases in the planning what is not intended. To fix this the calculation flag is set at planer simulation start for all deco gases.
Beside this the cursor is now placed in the bottom line at "next" instead of the first menu item.
author | Ideenmodellierer |
---|---|
date | Tue, 03 Sep 2024 20:46:42 +0200 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f411RETx | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 #puts "Flash banks:" | |
21 #flash banks | |
22 | |
23 #puts "Reading..." | |
24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
25 | |
26 #puts "Done." | |
27 #exit |