--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/code_part1/OSTC_code_asm_part1/docu/README.txt	Fri Feb 11 21:28:58 2011 +0100
@@ -0,0 +1,76 @@
+To recompile the OSTC code you will need to install the following:
+------------------------------------------------------------------
+
+ - A Mercurial client, to download the source code and updates easily.
+   TortoiseHg is free, and works well.
+
+ - The Microchip MPLab IDE. This is free, and enable to recompile
+   all the assembly code, link, and produce a .hex file.
+
+ - If you want to modify the decompression algorithm, you will also
+   need the MPLab C18 compiler. There is a demo free for the first
+   30 days.
+   If you don't modify p2_deco.c, you don't need the C18 compiler,
+   see below.
+
+ - The Tiny bootloader for windows, see the HW site.
+
+
+Creating a working project:
+---------------------------
+
+ - Launch the MPLab IDE.
+
+ - Create a new project (Project > Project Wizard...)
+   - Choose device PIC18F4685
+   - Select Microchip C18 Toolsuite   (if you installed the C18 compiler)
+     or     Microchip MPASM Toolsuite (if not)
+     --> Make sure the paths are corect.
+   - Choose a name and a directoty.
+
+   - Add the following files:
+     <my_source_path>/code_part1/OSTC_code_asm_part1/18f4685_ostc_mkII.lkr
+     <my_source_path>/code_part1/OSTC_code_asm_part1/MAIN.ASM
+     <my_source_path>/code_part1/OSTC_code_c_part2/p2_deco.o
+
+     (or use the .c instead of the .o if you have the C18 compiler)
+
+   - If you want to compile C code, configure it:
+     Project > Build Options... > Project > MPLab C18
+         General: Default storage = Overlay (-sco)
+         Optimization: Enable all
+
+ - Hit F10 to recompile everything.
+   --> You should get a .hex file where you saved your project.
+
+
+Installing the new firmware
+---------------------------
+
+ - Get the .hew file you want to flash onto the OSTC.
+
+ - Connect the OSTC, wake it up.
+
+ - Launch the Tiny bootloader. It should work for some time, trying to open
+   the communication port.
+
+ - Once it is ready, Click Browse to select the .hex file
+   ==> DO NOT HIT Write Flash YET !
+
+ - On the OSTC, go to the reset menu, select Reboot OSTC
+   ==> DO NOT CONFIRM YET !
+
+ - Click "Write Flash" button. Now you have 10sec to confirm on OSTC too.
+
+ - The bootloader should say it found a PIC18F6485 device, and start uploading.
+   The OSTC should have the blue and red led blinking rapidly.
+   The upload time is ~ 1 minute.
+
+ - Once done, the OSTC finishes its reboot.
+
+ - If you OSTC is stuck in some bad code, you can do the magic magnet reset
+   instead of choosing the reboot menu, during the 10sec timeslot after
+   starting bootloader write flash.
+
+
+