| Sun, 22 Dec 2024 21:19:21 +0100 |
Ideenmodellierer |
GNSS UTC in Date-Time menu:
Evo_2_23
|
| Thu, 19 Dec 2024 18:58:18 +0100 |
Ideenmodellierer |
Restructure Date/Time menu:
Evo_2_23
|
| Mon, 02 Dec 2024 11:16:10 +0100 |
heinrichsweikamp |
Add a line to the compass heading dive menu that shows the currently set heading to enable the
Evo_2_23
|
| Wed, 02 Oct 2024 22:18:19 +0200 |
Ideenmodellierer |
VPM table mode:
Evo_2_23
|
| Sat, 31 Aug 2024 17:35:52 +0200 |
Ideenmodellierer |
Added slow exit timer function:
Evo_2_23
|
| Sat, 09 Mar 2024 20:05:33 +0100 |
Ideenmodellierer |
Development bugfix menu id handling:
Evo_2_23
|
| Sun, 21 Jan 2024 22:24:36 +0100 |
Ideenmodellierer |
Added new PreDiveCheck info page:
Evo_2_23
|
| Sun, 17 Dec 2023 21:14:17 +0100 |
Ideenmodellierer |
Added event based display changes for big font view:
Evo_2_23
|
| Thu, 16 Nov 2023 20:37:20 +0100 |
Ideenmodellierer |
Added selection if an active gas shall be used for deco calculation or not
Evo_2_23
|
| Sun, 03 Sep 2023 18:03:49 +0200 |
Ideenmodellierer |
Bugfix CustomView selection during dive mode:
|
| Sun, 27 Aug 2023 20:59:12 +0200 |
Ideenmodellierer |
Added function to skip lines which are not needed for operation:
|
| Mon, 21 Aug 2023 17:20:07 +0200 |
heinrichsweikamp |
Adds a simple countdown timer, available as a custom view in surface and dive mode.
|
| Tue, 04 Jul 2023 14:39:06 +0200 |
heinrichsweikamp |
Define explicit setpoints for low / high / deco. Add an option to delay the switch to SPlow until all decompression has been cleared. (mikeller)
|
| Thu, 18 May 2023 09:49:17 +0200 |
heinrichsweikamp |
Add support for a configurable compass declination in a range of -99 to 99 degrees.
|
| Thu, 11 May 2023 12:13:03 +0200 |
heinrichsweikamp |
Add a shortcuts to change the setpoint to the loop to the 'normal' display when diving. It is only shown when diving in CCR mode and on the loop.
|
| Wed, 10 May 2023 16:25:39 +0200 |
heinrichsweikamp |
more menu items for the compass menu: Delete bearing, and reset to land based bearing. I have also re-enabled the real time bearing display in the menu - makes it easier to set the correct bearing. (mikeller)
|
