Mercurial > public > ostc4
graph
-
Revised automatic setpoint change. The proposed approach is essentially the approach used by most controllers of eCCR ('upshift' on descent, 'downshift' on ascent), so that the OSTC4 when used as a backup computer for eCCR will make the changes at the same time as the eCCR itself.Fri, 21 Apr 2023 09:48:23 +0200, by heinrichsweikamp
-
Deactivation of the 'fallback' option when the CCR mode is set to 'Fixed' - this makes it a little clearer that the option has no influence in this mode.Fri, 21 Apr 2023 09:47:06 +0200, by heinrichsweikamp
-
1.6.2 releaseThu, 13 Apr 2023 09:35:43 +0200, by heinrichsweikamp
-
Update build for testingWed, 12 Apr 2023 09:56:00 +0200, by heinrichsweikamp
-
change button default responsiveness to 100Wed, 12 Apr 2023 09:30:15 +0200, by heinrichsweikamp
-
After a firmware update, use the factory settings for button sensitivity if these exist, the default settings otherwise.Wed, 12 Apr 2023 09:24:44 +0200, by heinrichsweikamp
-
Update build for testingMon, 27 Mar 2023 10:04:53 +0200, by heinrichsweikamp
-
increase HAL_Delay to 10ms for cold-start-button resetSun, 26 Mar 2023 18:34:30 +0200, by heinrichsweikamp
-
Preparing a 1.6.2 release candidateSun, 26 Mar 2023 11:27:29 +0200, by heinrichsweikamp
-
Fix/handle negative scrubber timer valuesTue, 21 Mar 2023 12:57:37 +0100, by heinrichsweikamp
-
Quit simualted dives after the dive time set in the SIM tab.Tue, 21 Mar 2023 12:56:54 +0100, by heinrichsweikamp
-
Some compass improvements from mikellerFri, 17 Mar 2023 09:35:25 +0100, by heinrichsweikamp
-
- Colours for scrubber display when time remaining falls below a threshold valueWed, 15 Mar 2023 09:18:07 +0100, by heinrichsweikamp
-
Dev Bugfix: ignore analog out of bounds limits for DiveO2 sensor:Tue, 07 Mar 2023 22:14:20 +0100, by Ideenmodellierer