ostc4: revision graph

graph

less more | rev 779: (0) -300 -100 -15 +15 +100 tip

Added UART multiplexer support for DiveO2:
22 months ago, by Ideenmodellierer
Zusammenf?hren
22 months ago, by heinrichsweikamp
This is only showing if one of the compass views is visible. It should make it possible to verify that a correct heading is set as the user can see the compass readout when pushing the button. (mikeller)
22 months ago, by heinrichsweikamp
Add support for a configurable compass declination in a range of -99 to 99 degrees.
22 months ago, by heinrichsweikamp
Add a shortcuts to change the setpoint to the loop to the 'normal' display when diving. It is only shown when diving in CCR mode and on the loop.
23 months ago, by heinrichsweikamp
more menu items for the compass menu: Delete bearing, and reset to land based bearing. I have also re-enabled the real time bearing display in the menu - makes it easier to set the correct bearing. (mikeller)
23 months ago, by heinrichsweikamp
Menu shortcut for bailout / return to circuit when diving in CCR mode (mikeller)
23 months ago, by heinrichsweikamp
Fix character truncation when screen is flipped. This was causing the dive computer to lock up when in English Units with the screen flipped when the first decompression stop is shown using FONT_105.
23 months ago, by izzni
Revised automatic setpoint change. The proposed approach is essentially the approach used by most controllers of eCCR ('upshift' on descent, 'downshift' on ascent), so that the OSTC4 when used as a backup computer for eCCR will make the changes at the same time as the eCCR itself.
23 months ago, by heinrichsweikamp
CCR overview in surface mode. Makes it easy to quickly check that all settings (mode, setpoints, diluent, scrubber timer) are correct when preparing to dive (also makes the OC gas list available in surface mode for the same reason).
23 months ago, by heinrichsweikamp
Deactivation of the 'fallback' option when the CCR mode is set to 'Fixed' - this makes it a little clearer that the option has no influence in this mode.
23 months ago, by heinrichsweikamp
1.6.2 release
24 months ago, by heinrichsweikamp
Update build for testing
24 months ago, by heinrichsweikamp
change button default responsiveness to 100
24 months ago, by heinrichsweikamp
After a firmware update, use the factory settings for button sensitivity if these exist, the default settings otherwise.
24 months ago, by heinrichsweikamp

less more | rev 779: (0) -300 -100 -15 +15 +100 tip