Motion detection: Enable focus after focus calibration: In previous version the focus detection was disabled while operating menus, also for the viewport calibration entry. As result when calibrating the view, it took some time till the focus was displayed (most likely causing confusion by the diver). To avoid this the suspension is now stopped when the view is calibrated => OSTC will enter focus mode using the new value

# How to Create From Scratch a Project for _CPU2-RTE_ Code #

Follow the same procedure than for [CPU1](Detailed CPU1-Discovery Project.md), with changes:

- Create a new _board_ for processor:  
>   Series: `STM32F4`  
>   Mcu: `STM32F411xE`  
>   Debug: `JTAG`  

- Add `Small_CPU` linked source directory (instead of _Discovery_)

- Use linker script `OSTC4/Small_CPU/CPU2-F411.ld`