Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 648:ff2b393e290f

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Motion detection: Enable focus after focus calibration: In previous version the focus detection was disabled while operating menus, also for the viewport calibration entry. As result when calibrating the view, it took some time till the focus was displayed (most likely causing confusion by the diver). To avoid this the suspension is now stopped when the view is calibrated => OSTC will enter focus mode using the new value
author Ideenmodellierer
date Mon, 19 Apr 2021 20:14:20 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit