Mercurial > public > ostc4
view Documentations/dump-disc.cfg @ 246:ff0d23625cd5 bm-1
feature: replace Relative GF by saturation, computational only
Replace Relative GF by saturation. The saturation code is derived from
the hwOS repo. This commit only contains the Buhlmann computational part. In
the simulator, the numbers does look sane. The initial ascent from the
bottom phase stops at the deepest deco stop a little over GFlow, which is
correct in my view, as we still have some time to spend on this deepest
stop, and that stop ends very close to GFlow (obviously, a deepest stop
is typically short, as in 1 or 2 minutes). The deco finally ends at the
surface with a saturation value of GFhigh.
Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>
author | Jan Mulder <jlmulder@xs4all.nl> |
---|---|
date | Tue, 09 Apr 2019 15:38:31 +0200 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f427IIT6 set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run puts "Flash banks:" flash banks #puts "Reading FIRMWARE..." # Requires OpenOCD 0.10.0 / released January 2017 ? #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 #puts "Done." exit