Bugfix: set battery percentage correctly after RTE update When the RTE is rebooted, the battery percentage on the display is zeroed. However, when selecting SYS2-reboot-maintenance, the previously known battery percentage can be manually restored. Interestingly, when the restore reported a percentage A, choosing that resulted in a percentage B to be displayed again. With B much smaller than A. So, rebooting the RTE multiple times resulted in an seemingly empty battery, while it definitely is not. The reason for this is a relatively simple bug in the RTE code. This commit fixes the conversion between the internal LTC2941 registers and the percentage value to be displayed. Obviously, from and to the internal registers need to be symmetrical. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef PRESSURE_H
#define PRESSURE_H

#include <stdint.h>

uint8_t init_pressure(void);
uint8_t pressure_update(void);

uint8_t is_init_pressure_done(void);

void  pressure_sensor_get_pressure_raw(void);
void  pressure_sensor_get_temperature_raw(void);
void pressure_calculation(void);

float get_temperature(void);
float get_pressure_mbar(void);
float get_surface_mbar(void);

void init_surface_ring(void);
void update_surface_pressure(uint8_t call_rhythm_seconds);

uint32_t demo_modify_temperature_and_pressure(int32_t divetime_in_seconds, uint8_t subseconds, float ceiling_mbar);

#endif /* PRESSURE_H */