Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 918:f72613a152dd Evo_2_23

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Switch external interface tx communication to DMA: In the previous version the transmitting of data was done in polling mode. With the introduction of new sensors the length of commands send to the sensor may increase and have a impact to the runtim behavior of the SW. To avoid this the DMA transfers for TX has been activated.
author Ideenmodellierer
date Sun, 03 Nov 2024 15:40:55 +0100
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit