Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 810:e6827fcd7604

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Only jump to Sensor view during charging if sensors are connected: In the past it could happen that the charger view was replaced by the sensor view which was not displaying values because no sensors were connected => no added value in performing the switch. In the new version the automatic jump to the sensor view will only be performed if sennsors are connected.
author Ideenmodellierer
date Sun, 27 Aug 2023 20:55:57 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit