view Small_CPU/Inc/gpio.h @ 988:d9290c76b840 GasConsumption

OSTC4/5 joined code: In the previous version code differences between OSTC4/5 were identified using the ENABLE_GPIO_V2 compiler switch. In the new version this is done using the display version as indicator which OSTC model is in used. Since this is detected by Firmware the information is forwarded from there to the RTE. This causes a little delay in the GPIO initialization but this applies only to the cold start of the RTE which should not happen very often.
author ideenmodellierer
date Sun, 06 Apr 2025 21:02:17 +0200 (9 days ago)
parents e9c37071933b
children
line wrap: on
line source
/**
  ******************************************************************************
  * @file    gpio.h
  * @author  heinrichs weikamp gmbh
  * @version V0.0.1
  * @date    08-Dec-2024
  * @brief   new GPIO definitions (GPIO_V2)
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT(c) 2024 heinrichs weikamp</center></h2>
  *
  ******************************************************************************
  */ 

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef GPIO_H
#define GPIO_H

#ifdef __cplusplus
 extern "C" {
#endif

/* Includes ------------------------------------------------------------------*/

#include "configuration.h"

#define VIBRATION_CONTROL_PIN			GPIO_PIN_3		/* PortA */
#define LED_CONTROL_PIN_RED        		GPIO_PIN_2		/* PortA */
#define LED_CONTROL_PIN_GREEN      		GPIO_PIN_1		/* PortA */
#define MAINCPU_CONTROL_PIN				GPIO_PIN_0		/* PortC */
#define	GPS_POWER_CONTROL_PIN			GPIO_PIN_15		/* PortB */
#define	GPS_BCKP_CONTROL_PIN			GPIO_PIN_14		/* PortB */

void GPIO_LEDs_VIBRATION_Init(void);
void GPIO_GNSS_Init();
void GPIO_Power_MainCPU_Init(void);
void GPIO_Power_MainCPU_ON(void);
void GPIO_Power_MainCPU_OFF(void);


void GPIO_LED_RED_OFF(void);
void GPIO_LED_RED_ON(void);
void GPIO_LED_GREEN_OFF(void);
void GPIO_LED_GREEN_ON(void);
void GPIO_VIBRATION_OFF(void);
void GPIO_VIBRATION_ON(void);
void GPIO_GPS_OFF(void);
void GPIO_GPS_ON(void);
void GPIO_GPS_BCKP_OFF(void);
void GPIO_GPS_BCKP_ON(void);

uint8_t GPIO_GetVersion(void);
void GPIO_Activate_V2(void);
void GPIO_HandleBuzzer();
#endif
#ifdef __cplusplus
}
#endif /* GPIO_H */



/************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/