bugfix: correct packed main version number in dive header This fixes a rather mysterious bug. Users report that up to 1.3.5 beta, a correct version number is shown in libdivecomputer based applications (like in Subsurface, in the extra data tab). Careful examining the code in both libdivecomputer and the firmware shows a subtle error in the bit mask and shift operation to pack a full X.Y.Z.beta version number in 2 bytes (as is available in the dive header) in the firmware end (as the libdivecomputer code looks sane, assuming this is the right way to pack things). Likely, this bug crept in in the conversion from the closed source Keil period into the open source GCC setup of the code base. So its impossible to document the exact history of this problem here. Further notice that the main version number is only 1 of 3 version numbers, denoting the full version of the firmware (besides Font and RTE). Finally notice that this way of packing is limited to 2^5 bits (decimal 32), so we could easily build a 1.4.21, but not a 1.4.55. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit