view Small_CPU/Inc/uartProtocol_Sentinel.h @ 902:d4622533271d Evo_2_23

VPM table mode: Because of the model maths, usage of float data type and so on it may happen that the TTS decreases during ascent and continues calculation of the vpm. To keep the values stable the vpm table mode has been introduces. Instead of continously calculation of the stops the stop time is decreased if the diver is close to a deco stop. If the table is violated (e.g. by not doing gas change) the table will be updated to the new, longer runtime. The table will not be switch back to a shorter version in case e.g. the missed gas change is performed
author Ideenmodellierer
date Wed, 02 Oct 2024 22:18:19 +0200
parents c3dd461ca3f9
children
line wrap: on
line source

/**
  ******************************************************************************
  * @file    uartProtocol_Sentinel.h
  * @author  heinrichs weikamp gmbh
  * @version V0.0.1
  * @date    15-Jan-2024
  * @brief	 Interface functionality read data from Sentinel rebreather
  *
  @verbatim
  ==============================================================================
                        ##### How to use #####
  ==============================================================================
  @endverbatim
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT(c) 2014 heinrichs weikamp</center></h2>
  *
  ******************************************************************************
  */

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef UART_PROTOCOL_SENTINEL_H
#define UART_PROTOCOL_SENTINEL_H

#ifdef __cplusplus
 extern "C" {
#endif

/* Includes ------------------------------------------------------------------*/
#include "configuration.h"
#include "stm32f4xx_hal.h"

 typedef enum
  {
	UART_SENTINEL_INIT = 0,		/* Default Status for every sensor type */
	UART_SENTINEL_IDLE,			/* sensor detected and no communication pending */
	UART_SENTINEL_ERROR,
  	UART_SENTINEL_OPERATING,		/* normal operation */
  } uartSentinelStatus_t;

  typedef enum
  {
  	SENTRX_Ready= 0,					/* Initial state */
 	SENTRX_DetectStart,					/* validate start byte */
 	SENTRX_SelectData,					/* Data contained in this frame */
  	SENTRX_Data0,						/* Process incoming data */
 	SENTRX_Data1,
 	SENTRX_Data2,
 	SENTRX_Data3,
 	SENTRX_Data4,
 	SENTRX_Data5,
 	SENTRX_Data6,
 	SENTRX_Data7,
 	SENTRX_Data8,
 	SENTRX_Data9,
 	SENTRX_Data10,
 	SENTRX_Data11,
 	SENTRX_Data12,
 	SENTRX_DataComplete
  } receiveStateSentinel_t;


void uartSentinel_Control(void);
void uartSentinel_ProcessData(uint8_t data);
uint8_t uartSentinel_isSensorConnected();

#endif /* UART_PROTOCOL_SENTINEL_H */