Mercurial > public > ostc4
view Small_CPU/Inc/batteryCharger.h @ 902:d4622533271d Evo_2_23
VPM table mode:
Because of the model maths, usage of float data type and so on it may happen that the TTS decreases during ascent and continues calculation of the vpm. To keep the values stable the vpm table mode has been introduces. Instead of continously calculation of the stops the stop time is decreased if the diver is close to a deco stop. If the table is violated (e.g. by not doing gas change) the table will be updated to the new, longer runtime. The table will not be switch back to a shorter version in case e.g. the missed gas change is performed
| author | Ideenmodellierer |
|---|---|
| date | Wed, 02 Oct 2024 22:18:19 +0200 |
| parents | d32901746950 |
| children |
line wrap: on
line source
/** ****************************************************************************** * @file batteryCharger.h * @author heinrichs weikamp gmbh * @date 09-Dec-2014 * @version V0.0.1 * @since 09-Dec-2014 * @brief LTC4054 Standalone Linear Li-Ion Battery Charger * @verbatim ============================================================================== ##### How to use ##### ============================================================================== @endverbatim ****************************************************************************** * @attention * * <h2><center>© COPYRIGHT(c) 2015 heinrichs weikamp</center></h2> * ****************************************************************************** */ /* Define to prevent recursive inclusion -------------------------------------*/ #ifndef BATTERY_CHARGER_H #define BATTERY_CHARGER_H #ifdef __cplusplus extern "C" { #endif /* Includes ------------------------------------------------------------------*/ #include <stdint.h> #define CHARGE_IN_PIN GPIO_PIN_2 #define CHARGE_IN_GPIO_PORT GPIOC #define CHARGE_IN_GPIO_ENABLE() __GPIOC_CLK_ENABLE() #define CHARGE_OUT_PIN GPIO_PIN_1 #define CHARGE_OUT_GPIO_PORT GPIOC #define CHARGE_OUT_GPIO_ENABLE() __GPIOC_CLK_ENABLE() typedef enum { Charger_NotConnected = 0, /* This is identified reading CHARGE_IN_PIN == HIGH */ Charger_WarmUp, /* Charging started but counter did not yet reach a certain limit (used to debounce connect / disconnect events to avoid multiple increases of statistic charging cycle counter) */ Charger_Active, /* Charging identified by CHARGE_IN_PIN == LOW for a certain time */ Charger_Finished, Charger_LostConnection, /* Intermediate state to debounce disconnecting events (including charging error state like over temperature) */ Charger_ColdStart, /* Cold start condition => check if an loaded battery has been inserted */ Charger_END } chargerState_t; void init_battery_charger_status(void); void set_charge_state(chargerState_t newState); uint8_t get_charge_state(void); void ReInit_battery_charger_status_pins(void); void DeInit_battery_charger_status_pins(void); void battery_charger_get_status_and_contral_battery_gas_gauge(uint8_t cycleTimeBase); #ifdef __cplusplus } #endif #endif /* BATTERY_CHARGER_H */ /************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/