Mercurial > public > ostc4
view Small_CPU/Inc/uart.h @ 859:d32901746950 Evo_2_23
Improvment battery charger visualization:
In the previous version the green flash (charge complete) was shown even battery had not reached 100% charge. Root cause was that the pin signaling the end of charge could be raised for other reasons then a full battery. The new version will show the green flash only in case the battery is rated as full.
In addition the graph visualization has been updated to continously progress. In the previous version it only progressed in case the charge value changed. Especially at charging start the charger is doing some battery evaluation which does not increase the charge state. In such a case the graph seemed to be frozen.
author | Ideenmodellierer |
---|---|
date | Tue, 07 May 2024 21:20:33 +0200 |
parents | e9eba334b942 |
children | ad96f99ebc78 |
line wrap: on
line source
/** ****************************************************************************** * @file uart.h * @author heinrichs weikamp gmbh * @version V0.0.1 * @date 27-March-2014 * @brief button control * ****************************************************************************** * @attention * * <h2><center>© COPYRIGHT(c) 2015 heinrichs weikamp</center></h2> * ****************************************************************************** */ /* Define to prevent recursive inclusion -------------------------------------*/ #ifndef UART_H #define UART_H #ifdef __cplusplus extern "C" { #endif #include "stm32f4xx_hal.h" #define BUFFER_NODATA (7u) /* The read function needs a byte which indicated that no data for processing is available.*/ /* This byte shall never appear in a normal data steam */ void MX_USART1_UART_Init(void); void MX_USART1_UART_DeInit(void); void MX_USART1_DMA_Init(void); uint8_t UART_ButtonAdjust(uint8_t *array); void UART_StartDMA_Receiption(void); #ifdef ENABLE_CO2_SUPPORT void UART_HandleCO2Data(void); void DigitalCO2_SendCmd(uint8_t CO2Cmd, uint8_t *cmdString, uint8_t *cmdLength); #endif #ifdef ENABLE_SENTINEL_MODE void UART_HandleSentinelData(void); #endif uint8_t UART_isCO2Connected(); uint8_t UART_isSentinelConnected(); void UART_setTargetChannel(uint8_t channel); void UART_MUX_SelectAddress(uint8_t muxAddress); void UART_SendCmdString(uint8_t *cmdString); void UART_ReadData(uint8_t sensorType); void UART_FlushRxBuffer(void); void UART_ChangeBaudrate(uint32_t newBaudrate); void StringToInt(char *pstr, uint32_t *puInt32); void StringToUInt64(char *pstr, uint64_t *puint64); #ifdef __cplusplus } #endif #endif /* UART_H */ /************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/