Mercurial > public > ostc4
view Discovery/Src/display.c @ 859:d32901746950 Evo_2_23
Improvment battery charger visualization:
In the previous version the green flash (charge complete) was shown even battery had not reached 100% charge. Root cause was that the pin signaling the end of charge could be raised for other reasons then a full battery. The new version will show the green flash only in case the battery is rated as full.
In addition the graph visualization has been updated to continously progress. In the previous version it only progressed in case the charge value changed. Especially at charging start the charger is doing some battery evaluation which does not increase the charge state. In such a case the graph seemed to be frozen.
author | Ideenmodellierer |
---|---|
date | Tue, 07 May 2024 21:20:33 +0200 |
parents | 5ca177d2df5d |
children | f7318457df4d |
line wrap: on
line source
#include "stm32f4xx_hal.h" /* for HAL_Delay() */ #include "ostc.h" #include "display.h" #define ENABLE_EXTENDED_COMMANDS 0xB9 #define SET_POWER 0xB1 #define SLEEP_OUT 0x11 #define DISPLAY_INVERSION_OFF 0x20 #define MEMORY_ACCESS_ONTROL 0x36 #define INTERFACE_PIXEL_FORMAT 0x3A #define SET_RGB_INTERFACE_RELATED 0xB3 #define SET_DISPLAY_WAVEFORM 0xB4 #define SET_PANEL 0xCC #define SET_GAMMA_CURVE_RELATED 0xE0 #define DISPLAY_ON 0x29 #define DISPLAY_OFF 0x28 #define SLEEP_IN 0x10 static void Display_Error_Handler(void); void display_power_on__1_of_2__pre_RGB(void) { /* reset system */ HAL_GPIO_WritePin(DISPLAY_CSB_GPIO_PORT,DISPLAY_CSB_PIN,GPIO_PIN_SET); // chip select HAL_GPIO_WritePin(DISPLAY_RESETB_GPIO_PORT,DISPLAY_RESETB_PIN,GPIO_PIN_RESET); HAL_Delay(10); HAL_GPIO_WritePin(DISPLAY_RESETB_GPIO_PORT,DISPLAY_RESETB_PIN,GPIO_PIN_SET); HAL_Delay(10); /* RGB signals should be now for 2 frames or more (datasheet) */ } static void send(uint8_t *pData, uint16_t inputlength) { HAL_GPIO_WritePin(DISPLAY_CSB_GPIO_PORT,DISPLAY_CSB_PIN,GPIO_PIN_RESET); // chip select if(HAL_SPI_Transmit(&hspiDisplay,(uint8_t*)pData, inputlength, 10000) != HAL_OK) Display_Error_Handler(); while (HAL_SPI_GetState(&hspiDisplay) != HAL_SPI_STATE_READY) { } HAL_GPIO_WritePin(DISPLAY_CSB_GPIO_PORT,DISPLAY_CSB_PIN,GPIO_PIN_SET); // chip select } static uint16_t convert8to9to8(uint8_t *pInput, uint8_t *pOutput,uint16_t inputlength) { uint16_t outputlength; uint8_t readbit = 0x80;//0b1000000; uint8_t writebit = 0x40;//0b0100000; uint16_t i,j,k; outputlength = ((inputlength+7)/8)*9; for(i=0;i<outputlength;i++) pOutput[i] = 0; k = 0; for(i=0;i<inputlength;i++) { if(i != 0) { pOutput[k] |= writebit; // 9. bit writebit = writebit >> 1; if(writebit == 0) { writebit = 0x80; k++; } } for(j=0;j<8;j++) { if((pInput[i] & readbit) != 0) { pOutput[k] |= writebit; } readbit = readbit >> 1; if(readbit == 0) readbit = 0x80; writebit = writebit >> 1; if(writebit == 0) { writebit = 0x80; k++; } } } return outputlength; } void display_power_on__2_of_2__post_RGB(void) { uint8_t aTxBuffer[32]; uint8_t bTxBuffer[36]; uint16_t i,length; for(i=0;i<32;i++) aTxBuffer[i] = 0; for(i=0;i<36;i++) bTxBuffer[i] = 0; aTxBuffer[0] = ENABLE_EXTENDED_COMMANDS; aTxBuffer[1] = 0xFF; aTxBuffer[2] = 0x83; aTxBuffer[3] = 0x63; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,4); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = SET_POWER; aTxBuffer[1] = 0x81; aTxBuffer[2] = 0x24; aTxBuffer[3] = 0x04; aTxBuffer[4] = 0x02; aTxBuffer[5] = 0x02; aTxBuffer[6] = 0x03; aTxBuffer[7] = 0x10; aTxBuffer[8] = 0x10; aTxBuffer[9] = 0x34; aTxBuffer[10] = 0x3C; aTxBuffer[11] = 0x3F; aTxBuffer[12] = 0x3F; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,13); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = SLEEP_OUT; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,1); send((uint8_t*)bTxBuffer, length); HAL_Delay(5+1); aTxBuffer[0] = DISPLAY_INVERSION_OFF; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,1); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = MEMORY_ACCESS_ONTROL; aTxBuffer[1] = 0x00; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,2); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = INTERFACE_PIXEL_FORMAT; aTxBuffer[1] = 0x70; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,2); send((uint8_t*)bTxBuffer, length); HAL_Delay(120+20); aTxBuffer[0] = SET_POWER; aTxBuffer[1] = 0x78; aTxBuffer[2] = 0x24; aTxBuffer[3] = 0x04, aTxBuffer[4] = 0x02; aTxBuffer[5] = 0x02; aTxBuffer[6] = 0x03; aTxBuffer[7] = 0x10; aTxBuffer[8] = 0x10; aTxBuffer[9] = 0x34; aTxBuffer[10] = 0x3C; aTxBuffer[11] = 0x3F; aTxBuffer[12] = 0x3F; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,13); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = SET_RGB_INTERFACE_RELATED; aTxBuffer[1] = 0x01; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,2); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = SET_DISPLAY_WAVEFORM; aTxBuffer[1] = 0x00; aTxBuffer[2] = 0x08; aTxBuffer[3] = 0x56; aTxBuffer[4] = 0x07; aTxBuffer[5] = 0x01; aTxBuffer[6] = 0x01; aTxBuffer[7] = 0x4D; aTxBuffer[8] = 0x01; aTxBuffer[9] = 0x42; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,10); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = SET_PANEL; aTxBuffer[1] = 0x0B; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,2); send((uint8_t*)bTxBuffer, length); aTxBuffer[0] = SET_GAMMA_CURVE_RELATED; aTxBuffer[1] = 0x01; aTxBuffer[2] = 0x48; aTxBuffer[3] = 0x4D; aTxBuffer[4] = 0x4E; aTxBuffer[5] = 0x58; aTxBuffer[6] = 0xF6; aTxBuffer[7] = 0x0B; aTxBuffer[8] = 0x4E; aTxBuffer[9] = 0x12; aTxBuffer[10] = 0xD5; aTxBuffer[11] = 0x15; aTxBuffer[12] = 0x95; aTxBuffer[13] = 0x55; aTxBuffer[14] = 0x8E; aTxBuffer[15] = 0x11; aTxBuffer[16] = 0x01; aTxBuffer[17] = 0x48; aTxBuffer[18] = 0x4D; aTxBuffer[19] = 0x55; aTxBuffer[20] = 0x5F; aTxBuffer[21] = 0xFD; aTxBuffer[22] = 0x0A; aTxBuffer[23] = 0x4E; aTxBuffer[24] = 0x51; aTxBuffer[25] = 0xD3; aTxBuffer[26] = 0x17; aTxBuffer[27] = 0x95; aTxBuffer[28] = 0x96; aTxBuffer[29] = 0x4E; aTxBuffer[30] = 0x11; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,31); send((uint8_t*)bTxBuffer, length); HAL_Delay(5+1); aTxBuffer[0] = DISPLAY_ON; length = convert8to9to8((uint8_t*)aTxBuffer,(uint8_t*)bTxBuffer,1); send((uint8_t*)bTxBuffer, length); } static void Display_Error_Handler(void) { while(1) { } }